![]() ![]() Supported distributions: Ubuntu 20.04 (Focal Fossa) and Ubuntu 18.04 (Bionic Beaver). It works directly with the free Let’s Encrypt certificate authority to request (or renew) a certificate, prove ownership of the domain, and install the certificate on Apache (or other web servers). Certbot dramatically reduces the effort (and cost) of securing your websites with HTTPS. Link/ether 0a:00:27:00:00:00 brd ff:ff:ff:ff:ff:ffĨ: vboxnet1: mtu 1500 qdisc noop state DOWN mode DEFAULT group default qlen 1000 Link/ether 34:17:eb:ad:40:72 brd ff:ff:ff:ff:ff:ffħ: vboxnet0: mtu 1500 qdisc noop state DOWN mode DEFAULT group default qlen 1000 ip link showġ: lo: mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000 Thanks for any help!ĮDIT: Also, it seems odd to me that when the WireGuard VPN is running, there is no route in the route table. I could see that the routes were added with "route -n", but the high WireGuard metric for 0.0.0.0 didn't encourage traffic to be routed over the primary network connection.Īny suggestions on how to send only traffic for 10.x.x.x over the WireGuard VPN? Probably something simple I am missing. I added routes as suggested in that article to the Network Manager WireGuard setup, but everything is still routed over the WireGuard VPN. It basically assigned a route for the desired remote network to the PPP adapter, and then added a route for 0.0.0.0 with a high metric. ![]() I found a post on here Configuring routes so that vpn is only used for local resources showing how to add some routes for a PPP VPN to accomplish what I am trying to do. The WireGuard setup in Network Manager also has a "Use this connection only for resources on its network", but checking that with AllowedIps = 0.0.0.0/0 still sends all traffic over the VPN. I have tried changing AllowedIPs to addresses containing various permutations of 10.200.85.x/x and 10.0.15.x/x, It seems that changing AllowedIPs to anything but 0.0.0.0/0 prevents anything from getting routed over the VPN, and "ip route get" shows the route for all addresses going through the primary network connection. I only want traffic for 10.0.15.xxx routed through the WireGuard VPN. This works, except that ALL traffic on my client is routed through the WireGuard VPN. The computers I am trying to reach on the other side of the VPN are in the 10.0.15.xxx range. ![]() The plug-in reads the configuration file I got from the sys admin, which is below (network-manager also handles the startup and shutdown of the wg client): I am using the Wireguard VPN client on Ubuntu 20.04 through the network-manager plug-in. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |